Hydraulic Compression Tools

The 15B hand hydraulic tool was designed to accommodate compressing Izumi C-Connectors in tight quarters.

The EP-50 was designed to accept dies for BEKU type mechanical tool widely used in European countries.

The CN-58A was designed to accept both Burndy MD6 W insert dies and Kearney/Blackburn O type/OD58 insert dies.

The EP-410, hand operated compression tool features a two stage rapid advance pumping system.

The EP-431 is unique in that it has a large jaw opening of 31mm, and is able to splice 31mm outer diameter conductors.

The EP-510C, hand operated compression tool features a two stage rapid advance pumping system.

The UC-6B dieless compression tool was designed to install Anderson type connectors up to 500MCM.

The UC-6FT2 dieless compression tool was designed to install Anderson type connectors up to 750MCM.

The EP-50H was designed to accept dies for BEKU type mechanical tool widely used in European countries.

The CN-58H was designed to accept both Burndy MD6 W insert dies and Kearney/Blackburn O type/OD58 insert dies.

The EP-410H is a traditional C-head with a one inch jaw opening.

The EP-431 is a remote C-head that requires an external 700 bar or 10,000 PSI pumping source for operation.

The EP-510HC is a remote C-head that requires an external 700 bar or 10,000 PSI pumping source.

The EP-H130H is a H-head with a one inch jaw opening.

The UC-6H is a dieless remote head that requires an external 700 bar or 10,000 PSI pumping source.

The UC-6FTH2, dieless anderson type head, has a flip top opening and a pull pin locking mechanism to accept the larger connectors up to 750KCM.

The EP-610HS2 is a remote C-head that requires an external 700bar or 10,000 PSI pumping source.

The TEP-610HS2 is a single acting, 15 ton compression head made of TITANIUM material.

The EP-520C is a single acting, 30 metric ton press that is designed to compress sleeves and lugs up to 520mm2.

The EP-30D is a double acting hydraulic compression head that has hydraulic ram advance and retract.

The EP-60S compression head was designed as a portable tool for installing compression sleeves and terminals for transmission constuction and maintainence work.

The EP-60D is a double acting 60 ton press.

The EP-100W is a 100 ton compression head for full tension, transmission and substation connections and requires an external double acing 700 bar pumping source.

The TEP-104W is the lightest 100 ton compressor in the industry.

The EP-200W is a 200 ton class compression head which accepts shell type dies exclusively designed for the EP-200W.

The LP-430A hydraulic tol is directly powered by PTO (Power Take Off) from utility bucket trucks or any vehicle with a low pressure hydraulic circuit having line pressure of 140 bars or 2,000 PSI and a maximum flow of 35 litres/min or 9 GPM.

The P-200M is a multipurpose body suitable for various types of crimping, cutting, punching and angle beam fabricating operation.

Dies for smaller size C-Connectors and non-insulated terminals available.